or Connect
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › General Discussion › Will be getting a AMNPS and i have the Analog Masterbuilt 30' smoker
New Posts  All Forums:Forum Nav:

Will be getting a AMNPS and i have the Analog Masterbuilt 30' smoker

post #1 of 4
Thread Starter 


Ok so this the smoker i own. When i get the AMNPS what can i do to make sure it stays lit in this smoker?

post #2 of 4

I put a 3" top ven and pipet, and a few extra intake holes in the bottom . Open and close these holes with the leftover 3" metal disk

 

Temp probe(Maverick ET 732?) in the side just above the rack, where most of my smoking sits.

 

Since the top vent hole/pipe works so well, I used a silicone rubber gasket around the door. 

 

Hooked up a PID from Ebay parts and that runs my temp control from room temp to highs over 400. 

 

-Brian

post #3 of 4
Thread Starter 
I do not have the tools to do stuff like that I guess I'll have to get some tools .
post #4 of 4
Thread Starter 
Any tips without modification?
Edited by Jonathan Kozla - 12/1/15 at 4:19pm
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: General Discussion
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › General Discussion › Will be getting a AMNPS and i have the Analog Masterbuilt 30' smoker