or Connect
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › General Discussion › DIY Butcher Paper Holder/Cutter
New Posts  All Forums:Forum Nav:

DIY Butcher Paper Holder/Cutter

post #1 of 3
Thread Starter 
I went to a local paper goods supply store here to get a roll of butcher paper. They were out of both white & brown in the 24" rolls, so I went with the 36" roll of brown butcher paper. I figured I could use the 36" width & tear off enough to fit the ribs & briskets & wrap them. Its more than I'll use in who knows how many years. Anyway, I had some scrap lumber & made a roll holder & cutter.

Used a piece of aluminum angle as the cutter bar. The angle keeps it rigid across the span.




There are two springs at each end of the cutter bar. They keep pressure on the paper to hold it down when cutting the paper. Its hard to see here, but there is a 5/8" dowel across the width & the paper goes behind & under it for added tension in the roll.


It can also stand on end and the paper can be pulled & cut.


I probably over thought this a lot but its working. biggrin.gif
post #2 of 3

Very nice and great idea  thumb1.gif

post #3 of 3
Quote:
Originally Posted by dwhite1031 View Post

I probably over thought this a lot but its working. biggrin.gif

 

ROFLMAO....... I love it!

 

Points!!

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: General Discussion
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › General Discussion › DIY Butcher Paper Holder/Cutter