WSM Vent Diameter Question for PID Controller

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

booboohead

Newbie
Original poster
Nov 5, 2013
8
10
Hey folks,

I've built myself a DIY temp controller for my 18.5" WSM. The fan, PID, SSR etc. are all housed in a PVC conduit box with an exhaust I cut out for the hose. On the WSM I used 3/4' knockouts on one of the vents capping off 2 holes, as I've seen others use, and plan on running hose to the 3rd vent hole for the air.

I've read on various online sources that the vent holes are 3/4" but I believe that's OD. What are people using for the ID? Without drilling a hole in my WSM I am ultimately looking for a hose barb to male, Male to male with lock nut etc. type fitting.

Note: For those using the caps get Hillman (Lowes, HD). They were a true fit and once on, not an eyesore.

The Hillman Group 3/4 in. Chrome Hole Plug Model #: 881267

Thanks ever so much!
 
Hey thanks I was hoping to make one. Saw this online and may resort to if I can't fit anything.

Thanks for your reply !
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky