A little moose jerky

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

bladebuilder

Meat Mopper
Original poster
Made a couple pounds of moose jerky, call it a test run in the new smoke house. I used to use a MES, until it crapped out. It took hours, to drive off the moisture, and get a good chewey product that wasn't wet. Before that I used a Little Chief electric smoker.

So I tried a commercially available blend of spices, from a retailer in Edmonton, Alberta, called Mountain Blend. Added the appropriate amount of cure #1, as well as brown sugar, the spice blend was a tad hotter than I prefer. Then into the refer overnight. That gave me time to build the jerky tray for the smoke house. It is oak framed, and the mesh is 5 mesh stainless (5 squares per linear inch). Didnt get any before pics sorry 'bout that!

On the tray in the smoker, I used some of Todd's Pitmasters Choice, in the AMNPS


The jerky was done in under 3 hours, here it is cut for vac packing. Used the VacMaster Pro 260


And after packaging...


SWMBO, wanted to go get groceries, to this had more time in the smokehouse that I wanted, I would have pulled it earlier. Turned out drier than I was aiming for, but a successful first run.
 
  • Like
Reactions: pattyq
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky