Thanks Dave I was just running all those numbers using that site to get all my messurements and was thinking it needed to be 21 inches after realizing the 7 inches would be right at the 20inch wide mark.. Thank you for all your help!
Propane tank build - Page 4
SmokingMeatForums.com Top Picks
I don't know... LOL Im just trying to figure out what happened. I redid all my measurements and what you came up with should be right but it's not looking like its right. Im just trying to figure where I went wrong.....
Learning is good, very good.....
- 65 Posts. Joined 6/2013
- Location: South east ohio (noble county) approx 1000 ft in elevation
- Points: 12
- Select All Posts By This User
When it comes to low amp welders a clean welding surface is very important. this step cannot be skipped even with a 400a machine you must grind the surface before welding
with mig welders i recommend a 1 in wide clean area when I weld on new steel, increase this distance with dirty or rusty metal
due to the heat of welding it will ''pull'' any contamination to your weld