or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Other Builds › new smoker question
New Posts  All Forums:Forum Nav:

new smoker question

post #1 of 4
Thread Starter 
I plan to run a pid because my temp is all over the place can I wire the element around the switch and just use my pid for controlling temp their is somthing going on with the switch I think I would just like to go around it any suggestions would be greatly appreciated thanks
post #2 of 4

Here , this may help...   http://www.smokingmeatforums.com/newsearch?search=wiring+PID%27s&=Search

post #3 of 4
Hi Shane' I built a electric smoker with a PID. I used a relay to power element.

Smokin Monkey 🇬🇧
post #4 of 4
Thread Starter 
Ok thank you I was just going to buy a plug and play dual prope pid but my heating element has a switch problem so It was wandering if I can do away with the switch beings it will be plugged in to my pid so basically the element will be wide open and I should be abel to control with pid without burning any thing down rite
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Other Builds
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Other Builds › new smoker question