my 1st reverse flow smoker build

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

bearded mike

Fire Starter
Original poster
Oct 27, 2014
45
10
Victorville, Ca
Ok guys, I am new to this forum, I have been reading posts for a couple of year's on here. I finally decided to build my own reverse flow, used feldons calculator, wanted some input on my build. I am building a 36"w x 24" x 24" double racks, 24" x 20" 20" Firebox. 4" x 30" long smoke stack, fb/cc opening 4" x 20", diffuser plate will be 32" long by 24" wide, any advise would be appreciated!
 
I look forward to watching you build.

110.gif


Happy smoken.

David
 
  • Like
Reactions: bearded mike
Some of Feldon's calculations need to be adjusted for an RF, Be sure and post lots of pictures and ask questions as you go "If Needed"

Gary
 
  • Like
Reactions: bearded mike
Need advise on smoke stack, should I go with 4" round pipe 30" long placed at lower grate level, or should I go square? If so what size square and length? Input is needed and appreciated. Thanks
 
Ok I'm almost done with my rf build, smoke stack damper installed, fb air intakes installed, ash pan completed, just need to finish fb door latch , and make coal basket. Should be ready for test burn by weekend, wish me luck
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky