or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Cutting round end caps
New Posts  All Forums:Forum Nav:

Cutting round end caps

post #1 of 3
Thread Starter 

Guy's,

 

What is the most common way of cutting your side end caps out of plate steel if building a smoker using pipe instead of tanks? what is the most common used tool for this

 

Cheers,

 

Phil

post #2 of 3
Here is a link to a build using pipe. The guy was quite ingenious making his rounded end. There are a couple of ways shown there. The second one is the one I am talking about, but the first one works also.
http://www.smokingmeatforums.com/t/166551/20-pipe-rf-smoker
Geothermal built a smoker out of pipe and the end product looks like an antique tractor!! Realy cool thread!
Edited by Wolfman1955 - 10/21/14 at 6:04am
post #3 of 3
Thread Starter 

Many thanks, I will check it out

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Reverse Flow
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Cutting round end caps