or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › HElp with MES 40 thermostat
New Posts  All Forums:Forum Nav:

HElp with MES 40 thermostat

post #1 of 3
Thread Starter 

Last week I tried to smoke a small (3.7 lb) pork shoulder, and after 7 hours it was still 130, ended up having to trash it.

 

Today I did some ribs, 2-2-1, and when I pulled them out they didn't look right.  Temp was 120.

 

I'm testing now with a masterforge thermostat, and it is reading about 185 when MES says it's 260.

 

Obviously something is wrong with my thermostat.  Where in the unit is it, and any way to fix?  Or is unit just trash now?  Damn think is only a few months old and only used about 6 times.

post #2 of 3
Thread Starter 

Is it on the bottom shelf at the back of the unit?  THat's where I've been laying the AMNTS, I just moved it and the temp reading on the MES plummeted.  ANd last week was the first time I used it.  Hmmm.....

post #3 of 3

On the Gen II units, it is a round (roughly 1/2 inch) button on the back bulkhead of the smoker.  It is right of center, and near the bottom shelf.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Electric Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › HElp with MES 40 thermostat