or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › Not a good start with MES 40"
New Posts  All Forums:Forum Nav:

Not a good start with MES 40"

post #1 of 3
Thread Starter 

After much research here I ended up going with 1st all stainless version of the MES 40. While putting the thing the pin holding the latch in place sheared at either end. I have contact masterbuilt but was really hoping to season the thing today. Does anyone know of an off the shelf solution I could pick up from home depot that would require modifications to work? 


I have used the search function but unfortunately not found a previously discussed solution. 

post #2 of 3

Just lean a chair or a shovel up against the door. Long as the vent is cracked there should be little trying to open it. Temporary fix till the part comes in.

post #3 of 3

Or another temporary cure-----Bungee cords.

 

 

Bear

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Electric Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › Not a good start with MES 40"