24" X 48" RF calculation advice
- Thread starter smokingunny
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Finally got the FB door attached. Now all I have left to do is make the air intakes, attaché it to the CC and light a fire to check for leaks.
daytonasooner86
Newbie
curtisimo81
Smoke Blower
Got the air intakes cut and installed. Getting ready to weld the FB to the CC. Man I hope this thing works!
Last edited:
Son of a crap! I'm less than an hour from being ready to light a fire and what happens? I run out of welding wire. Guess I underestimated how much I needed.
lendecatural
Smoking Fanatic
They do. I've been using flux core because it's been so windy here. Plus, driving after a few beers would be a career ended for me.
I'm welding in the RF plate and I was wondering if some tiny gaps along the sides are ok or does it need to be fully welded?
Here she is. Frankensmoker. I plan on starting a new thread to better organize things. I just hope I did all the math correctly and it works.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 57
- General Discussion
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 41
- Blowing Smoke Around the Smoker.
-
Non fat dried milk
- Started by hog warden
- Replies: 37
- Sausage
-
Featured A couple thick strips please!
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
