or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › 24" X 48" RF calculation advice
New Posts  All Forums:Forum Nav:

24" X 48" RF calculation advice - Page 2

post #21 of 30
Thread Starter 
Got the door cut out. Not too bad considering it was all free hand.

post #22 of 30
Thread Starter 
Finally got the FB door attached. Now all I have left to do is make the air intakes, attaché it to the CC and light a fire to check for leaks.



post #23 of 30
Looks like it is coming along nicely
post #24 of 30

looks good!

post #25 of 30
Thread Starter 
Got the air intakes cut and installed. Getting ready to weld the FB to the CC. Man I hope this thing works!


Edited by SmokinGunny - 12/17/14 at 5:56pm
post #26 of 30
Thread Starter 
Son of a crap! I'm less than an hour from being ready to light a fire and what happens? I run out of welding wire. Guess I underestimated how much I needed.
post #27 of 30

Home Depot and Lowes usually carry solid wire if you can fit a small spool on your machine....

post #28 of 30
Thread Starter 
They do. I've been using flux core because it's been so windy here. Plus, driving after a few beers would be a career ended for me.
post #29 of 30
Thread Starter 
I'm welding in the RF plate and I was wondering if some tiny gaps along the sides are ok or does it need to be fully welded?
post #30 of 30
Thread Starter 
Here she is. Frankensmoker. I plan on starting a new thread to better organize things. I just hope I did all the math correctly and it works.



New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Reverse Flow
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › 24" X 48" RF calculation advice