› Forums › Smoking Meat (and other things) › Pork › Ribs on the CharBroil with A-Maze-N-Smoker (with Qview)
New Posts  All Forums:Forum Nav:

Ribs on the CharBroil with A-Maze-N-Smoker (with Qview)

post #1 of 3
Thread Starter 

Here is a set of ribs I just finished up --


I spent the entire day up on the roof of the house working on ripping off and replacing the roof around the chimney.


Thanks to Todd and the A-Maze-N-Smoker, these didn't require any attention from me at all for the smoking.


I get to have perfectly done ribs even though I had to fix my roof!

Before having an A-Maze-N, I'd have had to have given up on smoking this weekend...



What I do is  this:


Light up the Amazen according to Todds directions.


-remove one of the racks

-remove one of the three burners, usually the one on the left.

- Light the two burners on high, bring the whole grill up to temp from stone cold.

- Put the A-Maze-N down inside that left side of the grill.

"In a Charbroil Commercial series, it just rests right down on top of the frame of the grill. "


- PIG goes on the right side rack, over the two burners for the moment.


After the Amazen has gotten going and is producing decent smoke, around

5 minutes after putting it in, I slide the PIG over the left, above the Amazen.


The two remaining burners then go down on the lowest setting, and that gives me full temp control.

One burner on low is about 225, both burners on low is about 350.



After about 3 hours of not having to even go near the grill except to walk by

and sniff the the smoke and the pig ;-)


I pulled and wrapped the meat.



Here's a view of it with just the Amazen running.

post #2 of 3

Looks great man  Thumbs Up  My AMNPS was one of the best things I ever bought...

post #3 of 3
Tasty looking ribs! The A Maze N products are just that amazing! I use my 12" & 18" AMNTS all the time!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Pork › Forums › Smoking Meat (and other things) › Pork › Ribs on the CharBroil with A-Maze-N-Smoker (with Qview)