or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › UDS Builds › removing the finish from a factory weber lid
New Posts  All Forums:Forum Nav:

removing the finish from a factory weber lid

post #1 of 3
Thread Starter 
Will sand blasting remove it. Cause my grinders, and sanders only polish it :)
post #2 of 3

Check out my Weber lid mods. I explain how I got down to bare metal in my video.

 

 

Hope this helps. That coating is real sturdy and tough to get off. This is the only way I have been able to do it.

 

Chad

post #3 of 3
Thread Starter 

sandblasting worked very well.  a little too well. actually warped the rim a little bit.  a little hammering on a sand bag brought her right back into place though.  just got it back from the powder coater and it looks amazing.  

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: UDS Builds
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › UDS Builds › removing the finish from a factory weber lid