brinkmann pitmaster mods

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

waygu tim

Fire Starter
Original poster
Jul 17, 2012
50
56
goshen indiana
Last edited:
hi guys well i got my metal parts today we are about done on the smoker build the baffle plate is made out of 3/16 metal and the tuning plates are made of 1/4 metal need to finish the front shelf and brace the legs and extend the chimney down to grate level and replace the wheels and repaint it then put the seal on then i am done i am so happy right now  i did fire it up today i could the the difference right away it was amazing















 
Last edited:
Tim:

Looks great.  I am about to start a restoration of a BPD and want to make the same mods.  Do you happen to recall the measurements for the heat shield.  Top I can figure out, but 1) bottom and 2) some way to guesstimate the curve would be very helpful.
 
hi there i will try and help u the best way i can a email address or phone number that would be grate and make sure to use only dry wood is what i found works the best
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky