or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › brinkmann pitmaster mods
New Posts  All Forums:Forum Nav:

brinkmann pitmaster mods

post #1 of 7
Thread Starter 

hi all today i started work on my brinkmann pitmaster we did all of the design work and ordered the metal for it using expected metal for the charcoal basket and 1/4 inch metal for the baffle and turning plates

 

 

 

 

 

 

 


Edited by tim yoder - 4/4/14 at 8:34pm
post #2 of 7

Hello Tim.  Lookin good so far.  Good luck.  Keep Smokin!

Danny

post #3 of 7
Thread Starter 

hi guys well i got my metal parts today we are about done on the smoker build the baffle plate is made out of 3/16 metal and the tuning plates are made of 1/4 metal need to finish the front shelf and brace the legs and extend the chimney down to grate level and replace the wheels and repaint it then put the seal on then i am done i am so happy right now  i did fire it up today i could the the difference right away it was amazing

 

 

 

 

 

 

 

 

 

 

 

 

 

 

post #4 of 7
Thread Starter 
post #5 of 7

Tim:

 

Looks great.  I am about to start a restoration of a BPD and want to make the same mods.  Do you happen to recall the measurements for the heat shield.  Top I can figure out, but 1) bottom and 2) some way to guesstimate the curve would be very helpful.

post #6 of 7
Thread Starter 

hi there i will try and help u the best way i can a email address or phone number that would be grate and make sure to use only dry wood is what i found works the best

post #7 of 7
Tim:

Thanks for the speedy reply.

You can reach me at rob@aiello.net

Rob
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Smoker Builds
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › brinkmann pitmaster mods