Mongo - Stumps Clone Build - Gravity Feed Smoker
- Thread starter nicholson
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
zombie13xx
Newbie
Very nice looking build. I'm a huge fan of the stumps design built myself one a few years ago. Great job on your built.
smok-n-all-meat
Newbie
Great build. I too am a fan of the stumps clone and have one drawn up for my future project. I gotta give a thumbs up
spot on smokers
Newbie
Nicholson I tried making a gravity fed cooker on the back side of a pic cooker but I used a 3/4 valve instead cause the 2 1/2 was so pricey but I had trouble with my fire so you think that was the problem also it was about a foot under the actual fire
Sometimes even with a bigger valve establishing initial airflow can be an issue. I found that big valve of mine for $5 on ebay. You may need to buy, or make, a little blower system to attach to your valve. Usually once the coals are pretty well established it will burn just fine on its own, even with a smaller valve.
spot on smokers
Newbie
Getting it burning isn't so much the problem with the top open it's when I close the top when it's stops burning like it suppose to, guess installing a 2 1/2 inch nipple couldn't hurt anything to start with, thanks for the help
spot on smokers
Newbie
shane womack
Newbie
- Jan 31, 2015
- 1
- 10
Hey, do you still have the plans that you built this off of? I would love to take a look at them and see if this is something I could build. Thanks.
bruno994
Master of the Pit
sweet smokinbbq
Newbie
- Nov 11, 2015
- 3
- 10
krism715
Newbie
Great build! Can you tell me where I could purchase the raw materials to diy a smoker? Would you have a rough idea of gauge of steel and type of steel you used?
mendozer
Smoke Blower
how did you figure out the size or angle of the pellet distribution? is it regulated by any controller or air vent? What's the range you can get temps precisely?
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 57
- General Discussion
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 42
- Blowing Smoke Around the Smoker.
-
Non fat dried milk
- Started by hog warden
- Replies: 37
- Sausage
-
Featured A couple thick strips please!
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
