New Posts  All Forums:Forum Nav:

amnps issues - Page 2

post #21 of 26

i used all the racks when doing Jerky and Chicken this weekend the meat was evenly cooked i would say on all racks.

post #22 of 26

If the pellets are not making it around the corner, then it's most likely an air flow/oxygen issue or you didn't fill the row to the top with pellets.

 

MES Old Model

Light the AMNPS 5x8 and place it on the rails towards the bottom of the smoker

Pull the chip pan out about 1 1/2"

Pull the chip loader out 2"

Exhaust WIDE open

No water in the water pan

 

MES New Gen 2

Remove water pan and place on the floor

Light the AMNPS 5x8 and place it on the hole where the water pan used to sit

Pull the chip loader out 2" and rotate so it is in the "Dump" position

Exhaust WIDE open

No water in the water pan

 

Rows should be filled with pellets to the top

Below is a pic of an AMNPS that DOES NOT have enough pellets in it to continue burning

My customer could not get more than 2 hours of burning out of the tray.

Once we figured out he wasn't filling the rows with enough pellets, his problem was fixed

No Creosote! A-Maze-N Smokers

Reply
post #23 of 26
I received the amnps today and the pics do it no justice. It looked okay in pics, but this thing is heavy duty! I haven't used it but it's a well built piece of equipment. Any doubts i had about the quality are gone. Nice piece and i bought a heat gun from Wagner and it fires up pellets immediately. Just plug in and you're ready to start it up. It fits like it was made for the MES and can't wait to try it! Five stats to Todd on the quality.
post #24 of 26
Have not read all the posts so if this has been covered I do apologize. Just had a nightmare with mine. Tried all the heat the pellets in the smoker, dry them in the micro on a paper plate advice that was offered. In my case what worked wad to bury in pellets in a large pan. Take a small ruler and screet the top...like what is done when working concrete. Fill the rows right to the top. Get it burning, either with a small torch or by using the Rutland gel that Todd sells. After 10 minutes blow it out.
Mine burned for over 12 hours yesterday...
post #25 of 26
Quote:
Originally Posted by kennyp1114 View Post

It fits like it was made for the MES and can't wait to try it! 

 

It Was.

 

Bear

post #26 of 26
Quote:
Originally Posted by Bearcarver View Post

It Was.

Bear
I smoked for 3 1/2 hrs. and it burned about one third of row. Todd has a great product.
New Posts  All Forums:Forum Nav:
  Return Home