Another 250 gallon RF Build Thread (My first build)

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Getting ready to sit it on trailer. I am pretty excited! Welded a piece of tubing for a glide to square front with back.

uhamenyt.jpg

du5u3uga.jpg
 
Got done early today! She is set on trailer with wood box all done except a floor. Built the shelf 12" x 67" think it could of went out to 14 - 15"? I used 1/8" x 2" flat with 1" x 1" x 1/8" welded on inside to stiffen it up plus give me a lip to set expanded metal on. The wood box will be 12-1/2" deep x 73" long x 24" wide. I used 2" x 2" x 1/8" to frame in around wood box.

batemamu.jpg

rubedudy.jpg

9y6apyty.jpg
 
Smoker is almost done! Have the thermometer's in, shelf is done, changed necessary bolts from zinc to stainless, smoothed some of the welds.

u6ehesyh.jpg

u3ena7eh.jpg

eda6ysuv.jpg
9aze8y9a.jpg

tabemy7a.jpg
 
Tongue and Jack
zavymeqa.jpg


CC door hinges
e8abuqa8.jpg


FB hinges
8u4enyjy.jpg


Ran a 2" angle longways beside wood box under smoker to keep wood from falling out
9uty3udy.jpg


Approximately a 4' x 4' area in front of smoker for a small box, water containers, and maybe a small sink.
ugyve9u5.jpg


Support legs on smoker are 2" x 2" x 1/8" angle
2u3adu4y.jpg
 
I am as far as I can go Pig Ass until Friday. All doors seals are drying now and holes are plugged. So recess is now!
 
Awesome Pigs Asss has our chimney and counter weights. I will install them Friday. We will be ready for wood Saturday mid day after we power wash interior good.

atu9e6yh.jpg
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky