or Connect
New Posts  All Forums:Forum Nav:

Commercial Fridge Build

post #1 of 9
Thread Starter 
Hey everyone, been quite a long......long time since I've posted anything. And last night I decided to start my next build.
Here's a question, on this stainless fridge, what are the chances the inside being stainless? I believe it's galvanized and will have to get it out.
post #2 of 9

Have you put a magnet to it? Galvanized steel is magnetic, but so are cheaper grades of SS so you are only sure if magnet doesn't stick. Also Galvanized will shine up with vinegar.

post #3 of 9
Thread Starter 
Thanks TX, I'll try a magnet a lil later and cross my fingers it ain't magnetic lol
-Jeremy-
post #4 of 9
Thread Starter 
The innards of the fridge are not magnetic..... So it should be ok correct? I still plan on taking it out just to get the insulation out. But will clean it up and re use if possible.
post #5 of 9

You could also google the brand and model of the unit and see what the maker's specs were.  But if a magnet does not stick to it, it's not going to be galvanized steel.

post #6 of 9
Thread Starter 
looked up the specs and found that the interior is aluminum. Got the interior out with minimal damage.... I'll keep posting the progress.
post #7 of 9
Quote:
Originally Posted by AZHunter80 View Post

looked up the specs and found that the interior is aluminum. Got the interior out with minimal damage.... I'll keep posting the progress.

 

Boy, that looks familiar!  I feel your pain, brother! AR15firing.gif For the thinner stuff, I found a sturdy putty knife and hammer worked best to separate the foam from the metal. For the thicker, I used a pry bar with a wide blade to break off most of it. There is no solvent known to man that will dissolve that stuff. Believe me, I tried them all.

post #8 of 9
Don't know much on builds but that looks awesome, good luck on that ! icon14.gif WHB
post #9 of 9

And that is one reason my warmer project is sitting in storage at the other house still.

 

Any tips on how you separated the interior from the foam & shell would be welcomed.  Without tearing into mine, I still have not wrapped my head around how they put it together (at least where I can take it apart without destroying it).  I "think" if I pull the flat jamb panels which are riveted in on the inside edge of the door opening I may have access to the interior shell like I see in your photo.  Looks like it pulls out and then the top piece.  But I'm not certain.  And if you happened to take some photos of that portion of your disassembly, can you post them also?

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Fridge/Freezer Builds