or Connect
SmokingMeatForums.com › Forums › Announcements › Roll Call › question
New Posts  All Forums:Forum Nav:


post #1 of 5
Thread Starter 

i have a char grill smoker i want to remove grates and hang jerky width ways across, i have done this before on a different grill useing kabob sticks however this grill is a little wider any ideas on what to use

post #2 of 5

Hello and Welcome to our addiction.  A word of warning: There is no 12 step program for this one!  Many good folk here with a load of experience that they are more than willing to share.  If you have specific questions just start a thread and someone with experience will be along soon to offer advice.  All info you can provide us with such as smoker type, location and so on will help us answer any questions you may have.  Spend some time doing some research on the forums, tons of advice and recipes already available there.  We look forward to your contributions.  As for your question: NOTHING GALVANISED!  Dowel rod, concrete rebar, tree branches, bamboo,  2x2, copper tubing for just a few ideas.  Have fun.  Good luck.  Keep Smokin!


post #3 of 5

texas.gifHello and welcome from East Texas. This is a great site, lots of information and great people that are willing to throw in their two cents worth on about anything.   



post #4 of 5

Welcome Scotch  I've used small all thread bars from Home Depot. Just cut em the length you need. 

You will find plenty of friendly folks with great advice on this forum. Lt the search bar at the top of the page be your new friend.  There are over 1 million post on this forum.  And that a lot of powerful knowledge right at your finger tips. Or just ask! If you have not checked it out already, Give Jeff's 5 day ecourse a try.  It is free and full of great information to make you an even better smoker.

Again Welcome.


post #5 of 5
Thread Starter 

thanks for the advise guys i have some dowel rod laying around ill give that a shot first

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Roll Call
SmokingMeatForums.com › Forums › Announcements › Roll Call › question