or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Meat Thermometers › Mounting maverick ET 732
New Posts  All Forums:Forum Nav:

Mounting maverick ET 732

post #1 of 3
Thread Starter 

I want to make a hole for my probe wires to go through just curious should i mount the wires directly under the grate or right above in my UDS? thanks.

post #2 of 3

A lot of people are able run the probes through the top vent hole. My smoker is homemade and that is not an option because of the short probe wires. I put my hole a little higher than the grate so I can start to feed the wires and they normally lay on the grate so I can reach them. I think if you put the hole below the grate your smoker temp probe will always be trying to fall through the grate. Just my $.02

post #3 of 3
Thread Starter 

Ya mine is homemade to and my probe wires are short. I got two bolts to put into smoker so that i can put them next to each other and  just run the wires through the side and squeeze the little thing that usually mounts to the grate. So I'm thinking I'm going right below the grate.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Meat Thermometers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Meat Thermometers › Mounting maverick ET 732