Is that a galvanized stack?
Yep. I agitated it in a bucket of diluted muriatic acid to remove zinc from the surfaces in the cooker and where I had to weld.
I was able to get outside and work on it some more. Next step is the doors.
Got a little work done today. Flanging the lid is a pain. All I have is .188 x 2 and it's tough to bend but it turned out better than I expected.
I had to heat the parts on either end to get it bent. I guess I'll go behind and weld it up solid and cross my fingers that it doesn't pretzel.
I originally planned to put just legs but I'm thinking it is going to be really heavy. Have been kicking around mounting some tires to it to facilitate moving it around the yard and onto my trailer.
the smoker that is my profile picture I did that with smaller smoker to heavy to move . Im starting now that will have 4 tires and the front two will have a pull handle and will steer the tires are off a golf cart kind of fat (wide) nice talking Keep posting pictures so we can watch I will do the same
Not much to update Gary. I'm a little further along on the lid. I made a good score at the scrap yard to finish off the lid and the FB door. I've been thinking about what I'm going to use for the RF plate. Does anyone have a thought on what thickness to make it?
The plate I picked up from the yard looked a little thick and I was hoping it was just 5/16 but it is a full 3/8". The door and the RF plate are going to be ultra heavy. Conveniently, my friend offered an old boat trailer earlier today. I did a little welding and cutting this morning.
I test fit the lid and confirmed my wife's suggestion that i shouldn't have welded the inside. I've since cut 1/4" or so from the tank around the opening. It was freehand with the gas ax and looks it. I envisioned using a gasket to seal the lid and the FB door but I haven't seen one on the few smokers I've examined. Are gaskets necessary?