Hi All I just had a very HARD time getting casings 32/35mm on my 1/2 Grizzly stuffer tube..The little veins inside the casing would not let me slide the casing on center . The casings were going an a angle ..
So here is what I did to solve the problem at least for now..I started the casing got a couple of inches on , then I put the other end around my faucet, ran some water to open the casing, they went right on.. Had to let the water drain out before stuffing.
Next time I buy casing it will be the tubed kind.Should be much easier!!
Dan
So here is what I did to solve the problem at least for now..I started the casing got a couple of inches on , then I put the other end around my faucet, ran some water to open the casing, they went right on.. Had to let the water drain out before stuffing.
Next time I buy casing it will be the tubed kind.Should be much easier!!
Dan
Last edited: