or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Propane Smokers › Insulation and Coating Question
New Posts  All Forums:Forum Nav:

Insulation and Coating Question

post #1 of 2
Thread Starter 

I have a couple questions here.

 

Has anyone used some sort of a board insulation that is in some way glued or attached to the walls on a vertical smoker? I tried the hot water heater insulation but it's just too messy. I figure there is someone out there that has tried board insulation. Any ideas where I can order it from? I just want something neater and less messy than loose insulation. 

 

Also, what about the black coating that goes on many different types of grills? I have a side fire box grill that I left outside and it started to rust out. Is there a coating I can buy, then sand and apply?

post #2 of 2
Quote:
Originally Posted by bower4311 View Post

I have a couple questions here.

 

Has anyone used some sort of a board insulation that is in some way glued or attached to the walls on a vertical smoker? I tried the hot water heater insulation but it's just too messy. I figure there is someone out there that has tried board insulation. Any ideas where I can order it from? I just want something neater and less messy than loose insulation. 

 

http://www.smokingmeatforums.com/t/112976/insulating-a-propane-smoker

 

http://www.smokingmeatforums.com/t/51937/insulated-gosm-smoker

 

 

Also, what about the black coating that goes on many different types of grills? I have a side fire box grill that I left outside and it started to rust out. Is there a coating I can buy, then sand and apply?

 

High temp paint

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Propane Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Propane Smokers › Insulation and Coating Question