Request for pic of CharGriller Hinge

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

gianni

Newbie
Original poster
May 21, 2013
2
10
La Mirada CA
Hello All!

I'm new here and need a little help, please.  Can anyone with a CharGriller Super Pro post a pic of the upper body welded tab that mates to the cylindrical hinge on the lower body?  I'm in need of fabricating a similar tab that mates an older Super Pro top to a newer Super Pro (with Clevis pin) bottom.

A pics of the tab and clevis would be wonderfully helpful and gratefully appreciated!

Gianni
 
Hi Cliff,

Thank you much for taking the time to make and upload these images.  They are perfect!  I have located a 1/2" steel sleeve that fits into the lower body pivot hole perfectly.  Now I just need to determine the correct dimensions for the upper body hinge 'tab'.  My initial tests didn't work too well since the upper body would not open all the way.  I figure a few more tests and I'll be there.  Your pics will certainly help!

Thanks again,

John
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky