or Connect
New Posts  All Forums:Forum Nav:

Pine construction

post #1 of 9
Thread Starter 

Ok I have looked around a little and read opinions on plywood and particle board but I have a boat load of scrap lumber and just one question.

Most of the lumber is pine as in 2x4s, 2x6s, 2x8, 2x10s and 2x12's. I was thinking of doing the tongue and groove thing and building a smokehouse in my barn.

The bottom 4ft will be cement block. Is pine ok for the walls?

Your advice/opinions greatly appreciated.

thanks

 

Dan

post #2 of 9
Dan, I've seen a lot of smokehouses on here made out of pine so I think it should be just fine. Heck Pop's smokehouse is made out of plywood so if there was anything wrong with pine Pops sure wouldn't be using it!
post #3 of 9

Dan, morning....    I've had fires in my smoke houses over the years....  You might consider not building it inside the barn....  

Just a suggestion...    Grease burns pretty hot, and fast...   

 

Dave

post #4 of 9
Thread Starter 

Yeah not very good thinking on my part.- to be continued.

post #5 of 9

You can use pine. What you cannot use is pressure treated. Pine is safe when taking the proper precautions.

post #6 of 9
Quote:
Originally Posted by Jackal12 View Post

You can use pine. What you cannot use is pressure treated. Pine is safe when taking the proper precautions.

 

Pine is Great for smoke houses, outhouses, and carving Bears!!!

 

Can't beat it.

 

 

Bear

post #7 of 9

Yep! honestly the precuations are the same as any wood smoker. Backer board, fire control close by, etc

post #8 of 9
Thread Starter 

I have since decided not to build it in the barn. In fact I haven't started it yet.

I have aquired something I have never seen before, 2 inch thick plywood.

2ft wide and 8ft long.

I live right up the road from a place that makes insulated buildings and rafters. They have pallets of scrap almost on a daily basis and it's usually pine and free for the taking. The peices normally range between 3 and 4 1/2 ft long. They are 2x4s 2x6s 2x8s 2x10s and 2x12s. Sure make a nice partition in my basement lol. Anyhow, way to many things going on on the farm so I'll post pics when I get it finished.

post #9 of 9
Quote:
Originally Posted by Bearcarver View Post

Quote:
Originally Posted by Jackal12 View Post

You can use pine. What you cannot use is pressure treated. Pine is safe when taking the proper precautions.

Pine is Great for smoke houses, outhouses, and carving Bears!!!

Can't beat it.


Bear
Ill never forget our outhouse our deer lease. It was built of pine.. helped with the smell... good times those memories. .. thanks for the reminder ;)
And carving bears.. nice point there too ;)
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Smoke Houses