or Connect
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › Beef › First WSM Smoke - need advice for a small piece of brisket
New Posts  All Forums:Forum Nav:

First WSM Smoke - need advice for a small piece of brisket

post #1 of 4
Thread Starter 

I finally upgraded from a Brinkman ECB to a WSM and have been dying to try brisket. A friend who is a butcher gave me a pound and a half of the top - also called a "second cut" brisket (half of the smaller top section, with the fat cap) - I can't afford to risk ruining a whole brisket, and just wanted to test the smoker. (and why say no to free beef?!)

 

Should I just keep this on the smoker for about 2 hours and then foil? can I get a good bark with such a small piece? (it has a good fat cap)

 

(I mainly do chicken & turkey - so any brisket advice is greatly appreciated!)

Thank you!

post #2 of 4

You have half a point.  I have never done that small of a brisket cut before but a pretty good rule of thumb is 1.5 to 2 hrs per lb at 225-250*.  Depending what it weights and since it has a nice fat cap you might try to do it without the foil. 

post #3 of 4
Thread Starter 

Thanks for your response. I ended up making it last week, as it was my first wsm smoke I ended up with a high temp of 300 and think I killed most of it (too rubbery/tough). There were a few bits that came out ok but I think I will have to learn to have some patience & play with the smoker to get used to it! (I have made some great chicken and ribs on my modified ECB thanks to this forum, but was so excited to play with the WSM,,, Oh well!)

post #4 of 4

i myself just became an owner of a wsm. i look forward to leaning this thing inside and out.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Beef
SmokingMeatForums.com › Forums › Smoking Meat (and other things) › Beef › First WSM Smoke - need advice for a small piece of brisket