Has anyone tried waterproofing these probes with shrink tubing, the stuff used for insulating wire, where the metal probe meets the wire? Wondering if this would work.
Waterproofing Maverick ET73 probes
- Thread starter smokininidaho
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
irie
Meat Mopper
that should work great actually, only problem is after a while the heat might dry them out causing the tubing to crack/fall off but short term it should work excellent.
bama bbq
Master of the Pit
teflon shrink tubing should work. It has a temp range up to 500*. http://www.electroinsulation.com/hst5.htm
diggingdogfarm
Master of the Pit
Yes, I remember that.
It was Permatex sealant mentioned by viper1 in this thread......
http://www.smokingmeatforums.com/t/118760/maverick-or-not
~Martin
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 55
- General Discussion
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 39
- Blowing Smoke Around the Smoker.
-
Non fat dried milk
- Started by hog warden
- Replies: 37
- Sausage
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
-
Featured A couple thick strips please!
