SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Slicers, Grinders, Tools, Equipment › Need some help with purchasing an Auber
New Posts  All Forums:Forum Nav:

Need some help with purchasing an Auber

post #1 of 4
Thread Starter 

I am looking to purchase an Auber temp controller, however I am unsure which blower to get.  I have a 18.5" WSM and am sure the standard 6.5 blower would suffice.  However I was interested in hearing if the upgrade to the 20 would be beneficial or if it would be too much.  I do not do many high heat cooks.  Thanks in advance.

post #2 of 4

I use the standard blower and it works just fine. The temperature doesn't fluctulate too much even though the blower does run more than 45% of the time.   I'd be thinking the 20 cfm blower might run for short bursts and the temp would fluctulate more.

 

I'm interested to see what other people use

post #3 of 4

You might also email Auber and see what they say.  Couldn't hurt.

 

I haven't used one but I was under the impression the 20cfm was for large stick burners.  Too bad they don't offer a 10cfm or something in between the 6 and the 20.

post #4 of 4
Thread Starter 

Thanks for the info.  I took your advice and sent them an email.  I asked about a 10 as well.

New Posts  All Forums:Forum Nav:
  Return Home
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Slicers, Grinders, Tools, Equipment › Need some help with purchasing an Auber