or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › Casters on MES analog smoker?
New Posts  All Forums:Forum Nav:

Casters on MES analog smoker?

post #1 of 7
Thread Starter 
I just got a 30" MES analog smoker for Christmas. It's the one that has 4 legs. Has anyone installed casters on one of these? I love the smoker but I have been moving it around quite a bit. I was thinking about drilling one hole in the bottom of each leg, adding a reinforcement plate and attaching the casters through the hole. Any thoughts?
post #2 of 7

Check out this thread there is one or two examples of casters on MES.

post #3 of 7
Thread Starter 

Thanks! I'll check it out.

post #4 of 7

As long as you can get screws to fit into the holes and find small enough casters I would think it should work. I don't have a MES so I have never looked at the bottom of one but it it has any type of feet on it I would think they would screw on and you should be able to add casters.

post #5 of 7

Hey Jc03, I was in the same boat with my Master Forge a while ago.  I took a little different route than just casters...

 

Here's a post I did a while back.  Might give you an idea for something just a tad different.  Hope it helps.

 

http://www.smokingmeatforums.com/t/115867/time-to-roll-and-stop-leaking-on-my-concrete

 

-Salt

post #6 of 7
Thread Starter 
Thanks, looks like a great idea!
post #7 of 7
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Electric Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Electric Smokers › Casters on MES analog smoker?