or Connect
SmokingMeatForums.com › Forums › Announcements › Messages for All Guests and Members › Sunday smoke aka my fiasco
New Posts  All Forums:Forum Nav:

Sunday smoke aka my fiasco

post #1 of 14
Thread Starter 

decided saturday  night to smoke sunday.(1st mistake)

went sun am to local grocer and bought ribs ,pork chops and 10 lbs of leg 1/4's.

got the MES out and got it heating.

Put the chicken in to brine for a few hours while i trimmed up the ribs and seasoned  everything else.

 hit the ribs w/ rub and brown sugar and set them on the counter .

 seasoned up 4 ribeyes for the pit and by now the MES is reading 257 .Ready to load some meat. fired up my amns .foiled the water pan and filled half way w/ boiling water.

 loaded the MES w/ meat and closed the door. not getting any visual smoke from my AMNS . dropped a handfull of chips in the chute just in case.

Internal temp dropped to 140 and would not climb? it slowly climbed back to 176 and i couldn't figure it out. Reset MES ,No change. Temp slowly climbed to 180. reset MES again! By now i'm getting into danger zone time so i decide that the  old MES has finally

bit the dust and take everything out to finish in the oven.

 As i pulled the meat out of the MES it looked like it was close to done. checked the internals and the chicken was at 148 ,the ribs were real close on the bend test but had no drawback. Finished it all in the oven and to the fridge it went. will portion and vac seal today.

 Things i learned yesterday,

 Do not wait till the morning of smoke  to try and prep. Do not count on something working just because it did last week. When you are in a rush things will go from bad to worse

just because they can.

 BTW, I let my MES cool off before putting it in the shed. b4 putting it up i decided to plug it in and the dang thing worked fine w/ no meat in it.

 Don't know if the control panel is going out or the readout has gone bad or ???

 Time for a new smoker for sure.

 

post #2 of 14

Sounds like a great excuse for a new toy!

post #3 of 14

icon_cool.gif

Now thats a real Bummer Bob.

post #4 of 14

That sux. But at least you salvaged it and didn't have to toss it.

post #5 of 14

Look at the temp and other sensor..

 

Mine did the same thing and was all better after I cleaned them off.

 

  Have a great day!!

 

  Craig

post #6 of 14
Thread Starter 
Quote:
Originally Posted by fpnmf View Post

Look at the temp and other sensor..

 

Mine did the same thing and was all better after I cleaned them off.

 

  Have a great day!!

 

  Craig


You mean i actually have to clean that 1/2" of patina (crud ) off the inside to find the sensors?

 

 

post #7 of 14
Quote:
Originally Posted by eman View Post

 Things i learned yesterday,

 Do not wait till the morning of smoke  to try and prep. Do not count on something working just because it did last week. When you are in a rush things will go from bad to worse

just because they can.

 



and yer just now realizing? devil.gif

 

Quote:
Originally Posted by eman View Post

You mean i actually have to clean that 1/2" of patina (crud ) off the inside to find the sensors?

 

who knows what else you'll find?

post #8 of 14

Just remember, Murphy's law is always in effect.

 

Glad ya saved it though. Good Job.

 

 

Happy Smokin'

 

 

Mike

post #9 of 14
Thread Starter 
Quote:
Originally Posted by chefrob View Post

and yer just now realizing? devil.gif

 

who knows what else you'll find?



Maybe jimmy Hoffa who knows? LOL   My 800 watt  Mes has served many great  meals and has done a great job. I think i will retire it to cold smoke cabinet and purchase a new and improved 1200 watt.  If the stars align like i am planning the reverse flow will be ordered the 4th week of Jan 2012.

post #10 of 14
Quote:
Originally Posted by eman View Post

Maybe jimmy Hoffa who knows? LOL   My 800 watt  Mes has served many great  meals and has done a great job. I think i will retire it to cold smoke cabinet and purchase a new and improved 1200 watt.  If the stars align like i am planning the reverse flow will be ordered the 4th week of Jan 2012.



sounds like a great plan and let's git them stars aligned!

 

post #11 of 14

Bummer Bob but glad you saved all that meat

post #12 of 14

Sorry to hear that, but at least the food was ok.

 

Now do you really think that history DOESN'T repeat itself!

post #13 of 14

The end Result was good so all is good

post #14 of 14
Quote:
Originally Posted by eman View PostWhen you are in a rush things will go from bad to worse

just because they can.

 



 

Ain't that the truth Bob.

Glad it all worked out in the end for ya.

New Posts  All Forums:Forum Nav:
  Return Home
SmokingMeatForums.com › Forums › Announcements › Messages for All Guests and Members › Sunday smoke aka my fiasco