Wild west tradition

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

drunkenchicken

Newbie
Original poster
Jul 3, 2011
20
11
Enyone got any suggestions on any mods.  This is what I have to work with, no complaints just looking to improve.
 
8b5d18e3_7-3-11briskets009.jpg
 
A pic of it opened up would help.

In general, I would extend the chimney down to grate level with some aluminum dryer ducting. Get a couple of wired probes, that therm is useless placed that high above the grate.  Make sure you have a good coal basket in the firebox.  After that, monitor temps from right to left at meat level on the grate.  From there you should just have minor tinkering left to do.

Good luck and good smoking.
 
Results from this morning.  Just a little dry, went 12 hours with two 8lb briskets.
f684c23e_brisketready001.jpg
e6a781dc_brisketready002.jpg
583b29bf_brisketready003.jpg
9b5e87f9_brisketready004.jpg
 
I would definitely recommend a coal basket to keep the ash from choking off your coals and for better heat control.

Brisket looks good, but you said a bit dry.  What internal temp did you take it to?

Good luck and good smoking.
 
Yeah I need a basket for coals and I will try to lower vent stack.  Sure could use baffle plate.  Took the brisket up to 195.
 
I would get the other issues resolved with therms at the right and left of the pit before messing with a baffle.  I found on my unit that careful placement of my drip pans can provide a baffle effect.

Good luck and good smoking.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky