Jalapeno Snack Stick Q-View
- Thread starter bloc004
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Do you bring the sticks to a certain internal temp then pull and boil? Or do you just smoke for a couple hours, pull no matter what the temp and then boil? I am going to make some deer sticks this week and try boiling them.
butcherfamily
Fire Starter
- Sep 18, 2008
- 58
- 11
I don't try to cook the sausage in the smoker, the concept is just to 1, dry the casing in the smoker, 2, smoke the sausage. Whenever you feel the sausage has enough smoke, start boiling your pot (I use a big crab pot to cook 5 pounds at once). Then when boiling, pull your sausage from the smoker and place in the boiling water. Let boil maybe a couple minutes (water will probably stop boiling when you place 5 pounds of cooler sausage in the water). Then turn off the heat and let cook in the water for an additional 5 minutes or so.
The direct answer: yes I am not concerned about the internal temp at all.
Caveat: I have been using hot dog diameter casing. For the 32mm+ casing, I would probably increase the time in the water a bit.
The direct answer: yes I am not concerned about the internal temp at all.
Caveat: I have been using hot dog diameter casing. For the 32mm+ casing, I would probably increase the time in the water a bit.
I like the idea.
Do you have any pictures of any you did, to see what they look like after boiling?
Do they shrink some after they dry out?
Thanks,
Bear
couger78
Smoking Fanatic
I was under the impression that sausage is considered cooked with an IT at around 160+°F and that fats starts to melt (run out) at around 110°
With water boiling around 212° (versus a warm poach of about 160°), wouldn't a 'boil' be detrimental to the overall quality of the sausage/sticks?
That was the whole premise behind guys using a turkey roaster 160° water-bath & the like to 'finish' the links/sausage by bringing them up to temp post-smoke, then dropping 'em into an ice bath & then hang to bloom.
With water boiling around 212° (versus a warm poach of about 160°), wouldn't a 'boil' be detrimental to the overall quality of the sausage/sticks?
That was the whole premise behind guys using a turkey roaster 160° water-bath & the like to 'finish' the links/sausage by bringing them up to temp post-smoke, then dropping 'em into an ice bath & then hang to bloom.
Last edited:
I've been doing the water bath @ 170° and it will speed up the cooking time and dryout the sausage less.
I'll also pull them at 152°-154° internal.
I'll also pull them at 152°-154° internal.
Last edited:
butcherfamily
Fire Starter
- Sep 18, 2008
- 58
- 11
No, there is no shrinkage after. Do the same thing, pull out of water, rinse with cold water to decrease internal temp, and hang to bloom. I smoked this kielbasa last saturday in hot dog size casing because it was all I had. This is only 2 hours of smoke and hung for 45 minutes. I didn't want too much smoke flavor. My mom isn't a huge smoke flavor fan.
As DanMcG stated above, you will notice a huge difference in the casing texture.
As DanMcG stated above, you will notice a huge difference in the casing texture.
Last edited:
butcherfamily
Fire Starter
- Sep 18, 2008
- 58
- 11
I agree, I cook my sausage to 160. I can't say what internal temp fat runs out, but I agree, it does before it is done cooking most of the time.
As to the 212 being detrimental, remember the thermodynamic of it. The water will cool quickly and the heat transfer to the center is slow.
I know you say you do not like boiled sausage (green eggs and ham) but try it, try it, and you will see! On a boat, with a goat even.
-Think about cooking hotdogs. This is exactly how you do it. boil water, turn off heat, put in sausage, pull out after 6 minutes. Just try a small batch and you will see! Not to mention how much easier it is to not have to wonder "is it fully cooked yet, will someone get sick, should I keep smoking it?". All you have to worry about is if you think it has enough smoke. Then when it does, finish in water and have no further worries.
As to the 212 being detrimental, remember the thermodynamic of it. The water will cool quickly and the heat transfer to the center is slow.
I know you say you do not like boiled sausage (green eggs and ham) but try it, try it, and you will see! On a boat, with a goat even.
-Think about cooking hotdogs. This is exactly how you do it. boil water, turn off heat, put in sausage, pull out after 6 minutes. Just try a small batch and you will see! Not to mention how much easier it is to not have to wonder "is it fully cooked yet, will someone get sick, should I keep smoking it?". All you have to worry about is if you think it has enough smoke. Then when it does, finish in water and have no further worries.
Last edited:
butcherfamily
Fire Starter
- Sep 18, 2008
- 58
- 11
Yeah, that is why I use the boiling method, I can't afford shrinkage!
Shrinkage???
TJ
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Questions for RecTeq owners
- Started by schlotz
- Replies: 67
- Blowing Smoke Around the Smoker.
-
Spammer PMs, Anybody Else?
- Started by chilerelleno
- Replies: 65
- Blowing Smoke Around the Smoker.
-
Lost my dad yesterday
- Started by normanaj
- Replies: 40
- Blowing Smoke Around the Smoker.
-
On the Edge of Trying Sausage Making
- Started by BrianGSDTexoma
- Replies: 35
- Sausage
-
Took a stroll this afternoon
- Started by Buckeyedude
- Replies: 33
- Field and Stream
