SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › UDS Builds › Finally located a barrel..
New Posts  All Forums:Forum Nav:

Finally located a barrel..

post #1 of 7
Thread Starter 

So I finally got a barrel. This is my basic plan for the USD Build. Thoughts and opinions are greatly welcomed:

 

Burn Barrel well

Sand outside and whatnot, do rest of prep work as needed

Going to install three 3/4" vents with two check valves and one capped

Was going to place three shelves:

                First about 10 to 15" above fire box for water pan

                Second about 12" Down from top

                Third about 2.5" down from top for ribs while bbq other things at same time

 

Going to install a 2 or 3" vent tube with damper

Handle for lid

Paint with high heat paint

Build fire box with expaned metal and a smaller grate

 

 

 

This very rough and basic I know, but fill in the major blanks of I missed something obvious. The small stuff I pretty much know just not willing to type out..

 

Thanks

 

post #2 of 7

Ideally you want your lowest meat rack 24" from the bottom of the fire basket. How I make mine is, I go 27" from the bottom of the drum. I build my charcoal baskets with 2 or 3" legs.  Vents, I drill 1.5" on centre from the bottom of the drum and drill 1" holes to accommodate 3/4" pipe.

 

 

post #3 of 7
Thread Starter 

When you say bottom rack, you are referring to the rack I will be putting the water pan on? or for the meat?

 

post #4 of 7

I'm referring to the lowest meat rack. On my drums it ends up being around 7-8" from the top of the drum.

post #5 of 7
Thread Starter 

Gotcha.. thanks

post #6 of 7

Hello !

 

This topic intrests me because I will be doing UDS also.

 

I noticed in some photos where guys have (3) small valves installed low in the drum. I'm assuming this is to control air flow in. Is this more in-line with minion method (which I'm learning about) or is this to evenly control flow vs just 1 vent? 

 

Is the fire basket supposed to be off the floor of the drum? I want to simply burn wood (I have a lot) can/should I not just burn off the bottom of the barrel?

 

Sorry Dirtydog207 - I hope I'm not mowng your lawn, stealing your smoke etc etc :-)

Dave

post #7 of 7

Hi Dave!

 

Yeah, you want the bottom of the fire basket a few inches off the bottom of the barrel for airflow reasons. What that space does, is allows ash to fall from the basket yet still allow air to flow without choking the fire.
 

Quote:
Originally Posted by CanadianNewbie View Post

Hello !

 

This topic intrests me because I will be doing UDS also.

 

I noticed in some photos where guys have (3) small valves installed low in the drum. I'm assuming this is to control air flow in. Is this more in-line with minion method (which I'm learning about) or is this to evenly control flow vs just 1 vent? 

 

Is the fire basket supposed to be off the floor of the drum? I want to simply burn wood (I have a lot) can/should I not just burn off the bottom of the barrel?

 

Sorry Dirtydog207 - I hope I'm not mowng your lawn, stealing your smoke etc etc :-)

Dave



 

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: UDS Builds
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › UDS Builds › Finally located a barrel..