SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Charcoal Smokers › ECB Modification, how do you build the "charcoal rails"?
New Posts  All Forums:Forum Nav:

ECB Modification, how do you build the "charcoal rails"?

post #1 of 4
Thread Starter 

Hi, I have a ECB that I have made a few mods to, not much, but have gotten it to work fine.  However, I want to go hard core with it for smoking for the Super Bowl and am going to do the mods described at this website:

 

http://www.randyq.addr.com/ecb/ecb.html

 

My only question is, how do you build the charcoal rails described as part of Modification 2?  He doesn't go into explaining what he did, or how he built it, unless I completely missed it.  What are the charcoal rails and how are they attached to the charcoal grill from the smokey?

 

Thanks in advance for you help!!

 

post #2 of 4

I used expanded metal for a grate and the charcoal rails. Just bent the metal into a long oval and used mechanics wire to secure the ends and tie it to the grate in the center. It does not take much to hold it in place, once you add the charcoal it can't go anywhere. If this is not clear to you I can take a pic for you .   good luck

post #3 of 4

Found this shot I already had . I think I am going to mod. it and make it a little shorter in lenth so I can get a complete circle of charcoal on the grate. I have seen where some just use a tin soup can with the bottom cut out and holes drilled around it.01.jpg

post #4 of 4
Thread Starter 

thanks, i think i may do the soup can method for now,

i really appreciate the help!

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Charcoal Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Charcoal Smokers › ECB Modification, how do you build the "charcoal rails"?