grinding the lid on my 55 gallon drum

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

sniltz

Meat Mopper
Original poster
May 21, 2008
228
11
China Grove, NC
I am planning to make a UDS and the drums I have (4 of them) are from a bakery.  They have had canola oil in some and molasses in the other.  The question that I have is they are not a removable lid, they are a close lid.  How do I grind the lid off so that I can reuse the lid for my UDS?   What grinder do I use?  Do I use a standard grinder, a drimmel, I just don't know.  Any suggestions would be great.  Thanks.
 
Use a thin cut off wheel on a grinder. Think about cutting the drum 1" below the end. Then maybe expand the 1" lip outward so it overlaps the drum or expand the sides outward so the lid fits inside the drum walls. This can be accomplished with two hammers using one for support. It will take time and may be a solution to consider.
 
A die grinder and a 3" cutoff wheel should do the trick. Hammer down any edges that are sticking out as these will be quite sharp. I have see people use a Weber kettle lid as the top of their UDS.
 
Last edited:
I did the same thing with my smoker, but didn't reuse the lid. I now use the weber top as the lid. This will also give a little breathing room for the top rack.
 
I used a 1/2" cold chisel and a hammer, took about 5 min. per drum.

fc794838_UDS.001.jpg
2733ab9d_UDS.002.jpg
4c010422_UDS.003.jpg
9dea0bef_UDS.004.jpg
6b551e72_UDS.005.jpg
7240294d_UDS.006.jpg


It just occurred to me that this may be my first post here.  Hi all!
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky