Hay all, starting initial planning on my UDS and wanted to get some advice on how I should proceed. my initial question is, I have a 55 gallon drum that was used to hold motor oil, If I clean it out with heavy detergent, then do a long hot burn in it and finish up with a wire wheel with an angle grinder will it be ok to use? I was planning on following this site http://www.instructables.com/id/Build-Your-Own-Ugly-Drum-Smoker-UDS/ is there a better resource I could use for my first build?
thanks so much for your time!
thanks so much for your time!