Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I think I remember reading somewhere that one way to create a temp probe access in a wsm is by cutting a slot in the top edge of the mid section. If anyone out there in q-land has done this successfully, I'd appreciate details...even pics if you have them. Thanks.
Thanks. I did that but the inside diameter of the nipple is not large enough to accommodate the probe of the E85, which has a fairly large collar between the base of the probe and the wire.
I would take the probe to the nearest hardware store - not Home Depot, Lowes, etc... but a hardware store. The kind where the old guy has been there forever, gimpy and half blind but has EVERY answer for EVERY question and he is RIGHT 100% of the time. He will not only know what will work for you, but also he will know right where it is! Good luck!