smoke hollow gas smoker

Discussion in 'Roll Call' started by hosstd, Nov 24, 2009.

  1. hosstd

    hosstd Fire Starter

    i have noticeon here the high temps in the smoker and the needle valve mod ,i was wondering about the door ,does it seal good or is there mods for that too
     
  2. mballi3011

    mballi3011 Smoking Guru OTBS Member SMF Premier Member

    Is your door leaking alot or what is your concern with the door?? If you can take a picture of it then we might be able to help you out more. Hey it gives you another excuse if you need to smoke again.
     
  3. warthog

    warthog Smoking Fanatic

    Good luck with the door mod.
    Welcome to the SMF. Enjoy your stay.
     
  4. bandcollector

    bandcollector Master of the Pit OTBS Member ★ Lifetime Premier ★

    Didn't particularly like the high temperatures mine registered regardless of what I tried. It just frustrated me to a point that I built an Upright Drum Smoker and now use that exclusively. Sold the Smoke Hollow.

    Of course there are those on this sight who are expert in the use of their propane smokers and hopefully they will come along to offer some advice.

    Take care, John
     
  5. valien

    valien Fire Starter

    I have a Smoke Hollow #3 and only test/seasoned burned it in last weekend. Hoping to do a fattie this weekend and will see how the temps are.

    What's considered high temps?
     
  6. richoso1

    richoso1 Smoking Guru OTBS Member SMF Premier Member

    Most smokers will leak a little smoke frome the door and other areas, but not enough to effect the end product. Have you calibrated/compared therm readings? Some factory therms are way off, if so, replace.
     

Share This Page