Project begins!

Discussion in 'Fridge/Freezer Builds' started by tces, Nov 27, 2015.

  1. tces

    tces Newbie

    Hi I've posted about heating element and thank you for the input..
    I've chosen the brinkman 1500w
    That I'll run with an aub pid and get smoke from the amns for now.

    I've started removing plastic from the fridge and am planning on keeping the fiberglass insulation for now. (Want to get smoking!) My question is so I have to remove the wood that is beneath the plastic trim? I'll be Putin metal angle over it and a sheet on the door.
     
  2. tces

    tces Newbie

     
  3. doctord1955

    doctord1955 Smoking Fanatic

    I would for sure leave the insulation!  Is that wood or a Masonite type product?
     
  4. tces

    tces Newbie

    It's Masonite
     
  5. doctord1955

    doctord1955 Smoking Fanatic

    its just a backer board i bet so they could cover it with plastic!  If you can get heavy enough sheet metal bent to take the door closing against it and the heat id remove it!
     

Share This Page