Made from a $3 silicone spoon rest. Another matching piece on the inside. On my UDS-30. The probes for my new Flame Boss wouldn't fit through the hole I had for the Maverick probes.
Probe Wire management
- Thread starter damascusmaker
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Check out a "cable entrance connector" in the electrical dept. at Lowe's. They are only a couple of bucks and have a rubber grommet inside to protect the probe wires. I have never had a problem with mine. Several of the custom builders use this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Spammer PMs, Anybody Else?
- Started by chilerelleno
- Replies: 65
- Blowing Smoke Around the Smoker.
-
Lost my dad yesterday
- Started by normanaj
- Replies: 40
- Blowing Smoke Around the Smoker.
-
On the Edge of Trying Sausage Making
- Started by BrianGSDTexoma
- Replies: 35
- Sausage
-
Took a stroll this afternoon
- Started by Buckeyedude
- Replies: 33
- Field and Stream
