Probe Wire management

Discussion in 'Slicers, Grinders, Tools, Equipment' started by damascusmaker, Feb 18, 2016.

  1. Made from a $3 silicone spoon rest. Another matching piece on the inside. On my UDS-30. The probes for my new Flame Boss wouldn't fit through the hole I had for the Maverick probes.

     
  2. joe black

    joe black Master of the Pit OTBS Member

    Check out a "cable entrance connector" in the electrical dept. at Lowe's. They are only a couple of bucks and have a rubber grommet inside to protect the probe wires. I have never had a problem with mine. Several of the custom builders use this.
     
  3. Cool Joe, If I had known I bet it would have been easier. Next time.
     

Share This Page