pork butt sticks to cooking grate when taking it off the smoker??

Discussion in 'Pork' started by jerseydrew, Apr 17, 2013.

  1. jerseydrew

    jerseydrew Smoking Fanatic

    taking a pork butt off the smoker has become a tough proposition. first of all it is stupid hot, then it starts to fall apart in my hands and lastly a lot of the bottom of it sticks to the grill grates. 

    i am wondering if after the first few hours (once the smoke penetrates) should i put it in one of those foil tins?
     
  2. demosthenes9

    demosthenes9 Master of the Pit OTBS Member

    Foil tins work, so do Q-Matz.  That said, I'm convinced that the foil pans interfere with the smoke getting to the meat, but I can easily be wrong about that.   :)
     
  3. jerseydrew

    jerseydrew Smoking Fanatic

    that's why i would only put it in the pan after the smoke penetrates. supposedly smoke is done getting into the meat after 150 degrees. so i figure put the butt in the pan after it has been on the smoker bare for a few hours.
     
  4. truckerbob

    truckerbob Smoke Blower

    oops, wrong thread!
     
    Last edited: Apr 17, 2013
  5. demosthenes9

    demosthenes9 Master of the Pit OTBS Member

    My bad  :)  Guess it would help if I read the post all the way to the end  :)

    Now I'm feeling really dumb as the thought of doing it mid way never crossed my mind, even though I stop hitting my butts with smoke after about 6 hours.  :D
     
  6. demosthenes9

    demosthenes9 Master of the Pit OTBS Member

     
    Last edited: Apr 17, 2013
  7. truckerbob

    truckerbob Smoke Blower

    Sorry, I meant to put that in my thread... multitasking never was my strong suit!
     
  8. driedstick

    driedstick Smoking Guru OTBS Member SMF Premier Member

    Maybe hit your racks with a quick spray of Pam,, just a thought that's what I do with my racks seem to help a little.
     
  9. thsmormonsmokes

    thsmormonsmokes Smoking Fanatic

    When I have the sticky butt problem, I have a very large spatula I use.  It's big enough to scrape the entire butt off, even when it wants to stick a little.

    -Man, that sounds seriously wrong.

    Another option is to lift it and have a helper standing by with a spatula to scrape off any parts that stick.  You could also cook to a slightly lower IT to avoid it completely falling apart on you just from trying to pick it up.  Unless that's the texture you're going for.  Personally I prefer a tad more chew in it than that when it completely melts.  I want it to shred nice, but still chew like meat.  But that's just my personal preference.

    One other thing I've thought of is not rubbing the bottom.  If there's skin on it, the rub is going to waste anyway.  And when there's no skin, I usually scrape off the fat layer on the bottom.  My experience has been that it's the sugar in my rub that makes it sticky.
     
  10. chef willie

    chef willie Master of the Pit OTBS Member

    When mines done I usually pull the whole rack out and either run that into the house as is or put on a near-by handy cutting board and trot that into the house. Some guys here use those slick heat proof gloves to grab it but it still may fall apart that way
     
  11. michief

    michief Smoke Blower

    Yep, when I use gloves it leaves chunks behind so I started taking the grates inside
     
  12. rdknb

    rdknb Master of the Pit OTBS Member SMF Premier Member

    I am in the spray with pam and I  also take grate in.  I put it all on a big cookie sheet and take inside.
     
  13. austinl

    austinl Smoking Fanatic

    How hot are you cooking these things at?  I've never had anything stick to the grates of my smoker.  As for the foil pans; if you do not cover them its been my experience that smoke will still get down there over a long cook.  The only down side to doing most of your cooking sitting in a pan would be the need to drain some of the fat drippings off, which could present a whole new set of problems if you are having problems with it falling apart while moving it.  If you only use a pan the last couple hours of cooking most of the dripping collected will not be too greasy too toss back in the meat, and it is a lot easier to pull the meat in the same pan you plan on serving/storing it in.
     
  14. jirodriguez

    jirodriguez Master of the Pit OTBS Member SMF Premier Member

    Smoke will actually absorb the entire smoke, but the rate slows down a bit around 150°.

    The foil pans do work, but the bark on the bottom gets soft and greasy, so I don't use em. I would try spraying the racks with Pam, and get a big BBQ spatuala for helping to lift them.
     
  15. damon555

    damon555 Smoking Fanatic

    That's one of the numerous reasons why I smoke fat side down.....
     
  16. chef jimmyj

    chef jimmyj Smoking Guru Staff Member Moderator Group Lead OTBS Member

    Pam works well and the QMATZ are a Godsend. But spray the Grates outside as Pam on a Vinyl or Tile Kitchen Floor is slicker than Teflon. Has put many a Kitchen Rookie on their Butt in the Culinary School I taught in. I have no issue with using a Pan halfway through the Smoke. There is still plenty of smoke flavor and great Bark on the rest of the Butt. A couple of Paper Towels will make quick work of soaking up any grease in the bottom of the pan, too risky to try and pour it off...JJ
     
  17. s2k9k

    s2k9k AMNPS Test Group

    Q-Matz!!!!! I don't smoke anything without them anymore....has made life much easier!!!
     
  18. c farmer

    c farmer Smoking Guru Staff Member Moderator OTBS Member SMF Premier Member

    X2. Use them all the time.
     
  19. smoke slinger

    smoke slinger Smoking Fanatic

    I agree with AustinL as I have never had a problem of anything sticking to the grates.
     
  20. austinl

    austinl Smoking Fanatic

    Maybe the sticking problem has to do with the types of grates in some peoples' smokers. 
     

Share This Page