Painting smoker

Discussion in 'Reverse Flow' started by bubba mcnabb, Apr 25, 2014.

  1. bubba mcnabb

    bubba mcnabb Smoke Blower

    I've had a couple good trial runs with my smoker now I think I'm happy with it. So whats the best paint to use? I'm going to sand blast it. I've heard a lot of good about rustolium hi temp but is there any way of getting a good glossy finish? I will be using a paint gun so 2~3 coats?? another question you dont mess with sandblasting or painting the inside of cc do you? Just a good wipe down of oil? Thanks a million

    Sent from my SCH-I545 using Tapatalk
     
  2. bubba mcnabb

    bubba mcnabb Smoke Blower

    [​IMG]

    Sent from my SCH-I545 using Tapatalk
     
  3. mw-smoke

    mw-smoke Fire Starter

    Tried the Rustoleum high heat and also some other stuff sold at Autozone (they stock bbq paints there). 

    They've all burned off or just rusted through, especially on my firebox. Can't keep any paint on the firebox for more than a couple of uses. 

    Wonder if tractor enamel would do or if it'd gas off something nasty. 
     
  4. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Your smoker needs a mod or two.... Start a new thread with pics and stuff...... Dave
     
  5. bubba mcnabb

    bubba mcnabb Smoke Blower

    What kind of mods do I need? Thanks

    Sent from my SCH-I545 using Tapatalk
     
  6. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    You said you were happy with it.... ??????
     

Share This Page