Ok, Ok, I admit... I need some help.

Discussion in 'Reverse Flow' started by scottrd, Aug 15, 2014.

  1. I am new to this forum so I would like to say hello and I look forward to learning and sharing information. This is my first build. I'm an experienced welder and pretty damn good at building just about anything.

    I know that I want a 2x2x2 cooking chamber. I want to build a vertical reverse flow smoker with a water pan. I need some advice on firefox size and how to properly get the smoke into and out of the cooking chamber.

    I've seen a few different designs and I would like to incorporate some of both. Any advice would be greatly appreciated.
     
  2. timberjet

    timberjet Master of the Pit

    Welcome to SMF. There is a guy doing just this type of smoker at the moment. I saw the post several days ago. You might check out the build section or message Dave Omak. He is the man when it comes to smoker fabrication. 
     
    Last edited: Aug 15, 2014
  3. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Have at it... for the CC I would go with at least a 2x2x4 tall....




     
    Last edited: Aug 15, 2014
  4. lendecatural

    lendecatural Smoking Fanatic

    Check out the UDS section under smoker builds, if you are going vertical, the draft and intake systems used on those will be really close to what you want to duplicate. You could go with a firebox, pipe for chimney, then enter the bottom of your CC and have the smoke hit a plate with 2" gap all the way around then a stack out the top. Most of what you see in this build section is offset reverse flow with side fire boxes.
     
  5. timberjet

    timberjet Master of the Pit

    Dave, you are the man!
     

Share This Page