Needing Help

Discussion in 'Charcoal Smokers' started by rivet, May 18, 2008.

  1. rivet

    rivet Master of the Pit OTBS Member

    A couple of weeks ago some folks posted pictures of their Smoke n' Pits modifications; specifically the chimney extensions using stainless and regular steel exhaust pipes. I can't seem to find the threads or the pictures anywhere and was wondering if any of you all could help me locate them again. I would like to print out the pics and take them to my muffler shop and have them weld the mod, instead of me having to draw a picture or try to describe this to a non-smoker type. Thanks to any and all for the help!
     
  2. sumosmoke

    sumosmoke Master of the Pit OTBS Member SMF Premier Member

  3. rivet

    rivet Master of the Pit OTBS Member

    Thanks Fritz, that was one of the posts I saw, but it shows the chimney with dryer ducting, not the steel tubing I was looking for. There was another post showing that. Thanks for helping though!
     
  4. rivet

    rivet Master of the Pit OTBS Member

    Thanks Sumo, but shows ducting tube also. Appreciate it though!
     
  5. I used some flashing rolled up and stuck in the chimney. That way you can adjust it up or down. just another idea. You can see a picture of mine on the thread "What is the best way to seaon a Silver Smoker"[​IMG] .
     
  6. rivet

    rivet Master of the Pit OTBS Member

    Heyyyyy.........Go 'SKINS!!!!
     
  7. rivet

    rivet Master of the Pit OTBS Member

    [​IMG] Thanks Teeotee, that is the one! I appreciate you all's help on this. More mods for me.....woo-hoo!
     
  8. teeotee

    teeotee Smoking Fanatic

    No problem, i knew the one you was talking about, just had to find it.

    Have fun with the mods.
     
  9. ddave

    ddave Master of the Pit OTBS Member SMF Premier Member

    Rivet.

    The pictured SnP is mine and, in case the muffler shop has questions, that is a piece of 2-1/2" exhaust pipe with a slight "swedge" (muffler guy's term) to make it stay. It is not welded, just pushed into the hole. It fits fairly tight and I have never had it fall out.

    Have fun with the mods.

    Dave
     
  10. rivet

    rivet Master of the Pit OTBS Member

    Thanks too, Drowzy.... I'm familiar with the "swedge" and will talk to the guy about a baffle. 'Preciacte the pic!
     

Share This Page