My RF build

Discussion in 'Reverse Flow' started by timmo760, May 14, 2011.

  1. so i am finally getting around to posting my progress of my RF build. i am using an old air compressor tank. the tank is 5 feet long and 20 inches in diameter. it was a slow build until the last couple of weeks, i have been going into work to try and get it done soon. i was going to build a normal side fire box smoker, but after reading about RF's i decided to build one. i figured i might as well make it to where i wont need to change it later. 

    it's not completely done yet, but its getting there. hope you guys like it

    [​IMG]

    [​IMG]
     
  2. [​IMG]

    [​IMG]

    [​IMG]

    i need to finish the doors, make i grate for the fire box, make a side door and vent in the fire box, a chimney, and a couple racks and that should be it. unless i decide to make more changes. and paint of course
     
  3. tom37

    tom37 Master of the Pit OTBS Member SMF Premier Member

    Nice choice on making it a RF, you won't regret it.

    Nice workmanship as well. Great job.
     

Share This Page