My attempt at a cold smoke generator.

Discussion in 'Info and Practices' started by baz senior, Nov 9, 2013.

  1. Since joining this forum, I have been able to think of nothing else other than getting a decent cold smoker going. 

    I have had flu the last couple of weeks, so that has put back my plans for the build a bit, but has given me time to think things through, something Iam not normally known for.

    So I have took all my paperwork out of a two draw filing cabinet, and that is now down the shed awaiting transformation. The paperwork got put in a box and chucked in the attic, I have to keep the back bedroom a bit tidy, or I'll get my ear bent by the current Mrs Baz.

    I already have a ProQ cold smoke generator, which is similar to the A-Maze-N one, but not so beefy. But I also thought it would be good to have a cold smoke generator to add to it if needed, well of course it's going to be needed. 

    So with a bit of digging about I got together the plumbing fittings, and purchased the rest off Ebay.

    I shamelessly copied Grill Dads version, mostly as it looks good and I had most of the bit's, other than the air pump, connector, and cocktail shaker. Altogether, it cost me around £20. ($£30-35.)

    All in all it took me about a hour and a half to make, and Iam fairly happy with the result, but this won't be complete until I see it working and I have smoke coming out of it. I have only drilled a small hole in the base to start with, 4mm (5/32"), and will see how this goes before making it bigger, or putting more holes in it. What I don't want is to allow too much air in so it gives it enough air to burst into flame, and generate heat.

    I would also suggest that when you have finished any soldering, that you wash it out, this will get rid of any flux left in the pipes. I might be being too cautious but I don't want the smell of that in the smoke.

    So here it is so far, when I get it fired up I'll update the post.

     
    Last edited by a moderator: Nov 9, 2013
  2. bmudd14474

    bmudd14474 Smoking Guru Staff Member Administrator Group Lead OTBS Member SMF Premier Member

    looks great. Cant wait to see it in action
     
  3. Hello Baz.  Lookin good.

    Danny
     

Share This Page