- Jul 4, 2014
- 4
- 10
I am new to me owner of a non-working Masterbuilt smoker (Model # 20070408). I love this forum and cannot wait to get it up and running so I can start smoking.
The Story:The neutral wire connection on the control board (the board underneath) was bad. In the process of diagnosing this I shorted out the rest of the board (I think). I called Masterbuilt but no replacement parts available. I looking for ideas and options to get it up and running. I have been given an ultimatum to get it working or gone as cheaply and quickly as possible because it has just been sitting around all summer.
Other details: I bought it because it was only $20 at a garage sale and looked barely used. When I got it home it would not heat up. With the help of this forum I new the heating elements were usually the issue so I took it apart and got good resistance across the heating element but could not get a voltage reading across it. I traced it down to the line going from the element to the board underneath, but as I was checking the voltage the hot line going to the element hit the case and arced. Now I get no voltage anywhere in the system.
Any help would be great. With instructions I am pretty good at most repairs but my electronics knowledge is limited.
The Story:The neutral wire connection on the control board (the board underneath) was bad. In the process of diagnosing this I shorted out the rest of the board (I think). I called Masterbuilt but no replacement parts available. I looking for ideas and options to get it up and running. I have been given an ultimatum to get it working or gone as cheaply and quickly as possible because it has just been sitting around all summer.
Other details: I bought it because it was only $20 at a garage sale and looked barely used. When I got it home it would not heat up. With the help of this forum I new the heating elements were usually the issue so I took it apart and got good resistance across the heating element but could not get a voltage reading across it. I traced it down to the line going from the element to the board underneath, but as I was checking the voltage the hot line going to the element hit the case and arced. Now I get no voltage anywhere in the system.
Any help would be great. With instructions I am pretty good at most repairs but my electronics knowledge is limited.
Last edited: